Select Page

Contractor Pack Quote Request

 

For contractors ordering in quantities of 15 or more, please use the form below for a quote.

  • Let's Begin Building Your Discounted Contractor Pack!

    *SELECT WOOD SPECIES

    Paintable / Paint Grade Wood Options are: Birch, Maple, White Pine, Yellow Pine, or Poplar. Birch is the best as it is strong with tight pores and the most resistant to temperature changes and humidity.


    *VENT LOCATION

    *VENT FIT

    • Self-Rimming (surface mount / drop in) has a standard 7/8" lip on each side. 

    This means a 4 x 10" duct opening size, will have a vent w/ an overall size of 5.75 x 11.75"

    • Flush Mount with Frame will be flush with new floor installations. This will need to be installed w/in your floor to be flush. For 4 x 10" duct opening size there's an approx. overall size 6.875 x 12.875" with the frame included.

     

    • TrimLine Flush Mount (w/out separate frame) is a favored flush vent design, resting on subfloor. For 4 x 10" duct opening size will have a standard overall size of 5 x 11 x ?" (floor thickness)

    **Please note if you have a floating floor the Self-Rimming fit is recommended.**

    *FLOOR THICKNESS FOR FLUSH MOUNT WITH FRAME

    We use a standard thickness of 3/4", however, we can make them most any thickness you need. For non-standard thicknesses there may be an additional fee.

    *FLOOR THICKNESS FOR TRIMLINE FLUSH MOUNT (WITHOUT FRAME)

    We use a standard thickness of 3/4", however, we can make them most any thickness you need. For non-standard thicknesses there may be an additional fee.


    *VENT FIT

    • Self-Rimming (surface mount / drop in) has a standard 7/8" lip on each side. 

    This means a 4 x 10" duct opening size, will have a vent w/ an overall size of 5.75 x 11.75"

    • Surface / Flush Mount (w/out separate frame) has straight edges of 1/2" solid border each side.

    This means a 4 x 10" duct opening size will have a standard overall size of 5 x 11 x ?" (thickness)

     

    *SURFACE THICKNESS FOR SURFACE/FLUSH MOUNT

    We use a standard thickness of 3/4", however, we can make them most any thickness you need. For non-standard thicknesses there may be an additional fee.


    *VENT DESIGN / STYLE

    Register Style: Louvers diffuse the air in 2 directions

    Grate Style: Square grid pattern is the strongest most loade bearing design of all, while maximizing air flow

    Shaker Style: Linear slats are straight up without any angle, parallel to the short dimension

    Linear Style: Linear slats are straight up without any angle, parallel with the long dimension


    *DUCT OPENING SIZE

    All sizes are ordered by duct opening size, per industry  standards. The back of your vent will nest into the duct opening for more load bearing support, this measurement also allows us to understand the air flow size.


    *CHOOSE UNFINISHED OR STAINED

    All vents are purchased unfinished so you can match to your location. If you need us to add staining, we use any of the Minwax Oil Based Stains. Our staining is applied with a 4 way spray getting into all those little crevices.

    *FINISH TYPE


    *NEED DAMPERS?

    Most of our customers are professionals and do not required dampers. We do carry metal dampers if you prefer to add them. Dampers must be requested before construction of the vents, as the vents have to be constructed differently.


    QUESTIONS / COMMENTS?

    *QUESTIONS / COMMENTS

    OPTIONAL PHOTO UPLOAD PT. 1

    OPTIONAL PHOTO UPLOAD PT. 2